Provides access to a specific physical device to dial a modem or
    link to an external device.

    Format

      DIAL_OUT  device-name[:]

1 - Parameter

 device-name[:]

    Supplies the name of a device over which the network connection
    is made. The device name has the form ddcu where dd is the device
    code, c is the controller designation, and u is the unit number.
    LAN devices are specified as the name of the device that is unit
    0. For example, the first terminal device on a LAN is specified
    as TTA0, the second as TTB0.

2 - Qualifiers

 2.1 - /BREAK

       /BREAK=break-character

    Specifies a character sequence that you can use to interrupt the
    signal being currently transmitted. To interrupt the signal, type
    Ctrl/break-character. You can select any ASCII character from @
    though Z, except C, M, Q, S, and Y. The default break character
    is ~.

 2.2 - /DISCONNECT

       /DISCONNECT=disconnect-character

    Specifies a character sequence that you can use to terminate
    DIAL_OUT mode. To disconnect the call, type Ctrl/disconnect-
    character. You can select any ASCII character from @ though Z,
    except C, M, Q, S, and Y. The default disconnect character is \.

 2.3 - /SWITCH

       /SWITCH=switch-character

    Specifies a character sequence that you can use to switch the
    line to PPP mode. To activate PPP mode, type Ctrl/switch-
    character. You can select any ASCII character from @ though Z,
    except C, M, Q, S, and Y. The default switch character is @.

    Similar to the CONNECT command, this qualifier switches a
    line into PPP mode. If the packet negotiations fail, PPPD
    exits and the line is left in terminal mode. If line is set to
    /MODEM and /NOHANGUP, this can result in extraneous data, the
    ASCII representation of Internet Protocol (IP) packets, being
    transmitted across the open line.